allow a printer to raise the default status timeout

The PT-E560BT stays busy about 2.2 s after even an 8 mm label, so the
1 second default timeout cannot succeed on a job sent straight after
another: printing five chained labels gives a strip carrying three of
them. ptouch-print reports the timeout and exits non-zero correctly every
time, but no amount of waiting helps when the default is below the
printer's fixed overhead.

Add a trailing min_timeout to the device table. Every other row keeps its
initialiser and gets 0, which resolves to the old default of 1; only the
E560BT carries a value. An explicit --timeout always wins.

Raising the global default would also be defensible: ptouch_getstatus()
returns as soon as the status arrives, measured 0.13 s with --timeout 30
against 0.14 s with --timeout 1, so a higher ceiling costs nothing on a
printer that is ready. But that is a judgement about printers I do not
have, so this keeps it to the one that was measured.

src/libptouch.c

@@ -107,7 +107,7 @@ struct _pt_dev_info ptdevs[] = {
 	/* 3,5/6/9/12/18 mm TZe Tapes, 12mm and 18mm tested */
 	/* 5,2/9/11,2 mm HSe heat shrink tubes not tested, probably requiring extension of struct _pt_tape_info */
 	{0x04f9, 0x2201, "PT-E310BT", 128, 180, FLAG_P700_INIT|FLAG_USE_INFO_CMD|FLAG_D460BT_MAGIC, 0},
-	{0x04f9, 0x2203, "PT-E560BT", 128, 180, FLAG_P700_INIT|FLAG_USE_INFO_CMD|FLAG_D460BT_MAGIC, 0},
+	{0x04f9, 0x2203, "PT-E560BT", 128, 180, FLAG_P700_INIT|FLAG_USE_INFO_CMD|FLAG_D460BT_MAGIC, 0, 10},
 	{0,0,"",0,0,0,0}
 };